Back to Penobscot Bay Watch
Maine Dept of Environmental Protection files on Delta Chemical Searsport facility wastes
Sent 2/5/96 from MDEP Bangor office. (Karen Canute) by fax:
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
9/14/90 testing of 'Alum Reactor Waste
# 1 by Maine Environmental Laboratory
for B. Gower of Delta Chemical, Inc.
"Toxicity Characteristic Leaching Procedure."
This study examined 'reactor waste' for
___________ Mg/L Detected__________Detect limit_____Regulatory Limit
Arsenic __________ 0.29 __________0.01__________ 5.0
Barium __________ <0.5 __________ 0.5 __________ 100.0
cadmium __________ <0.01 __________ 0.01 __________ 1.0
chromium __________ 1.0 __________ 0.2 __________5.0
lead _______________ <0.1 __________ 0.1 __________ 5.0
Mercury __________ <0.002__________ 0.002 __________0.2
Selenium __________ <0.01 __________ 0.01 __________ 1.0
Silver __________ <0.1 __________0.1 __________ 5.0
Extraction Data:
Initial pH: 2.7 pH units
Final pH: 3.8 pH units
Extraction : 18 hours
Extraction: Fluid # 1
(Handwritten note says "Alum Process Lagoon")
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
DOCUMENT 2. Field Identification NA
Aluminate Filter Waste Matrix: Solid
Moisture ____63.3_______ 0.1
Detectable levels of the following were found: Parameter= Result Detection limit Parameter= (ug/g)
____________________Result__________Detection Limit
Aluminum __________ 140,000.0 __________ 220.0
Calcium __________ 590.0 __________ 22.0
Chromium __________ 3.5 __________ 2.2
Copper __________ 140.0 __________ 4.3
Iron __________ 1,500.0 __________ 6.5
Lead __________ 28.0 __________ 11.0
Magnesium __________ 250.0 __________ 22.0
Manganese __________ 14.0 __________ 1.1
Mercury __________ 1.6 __________0.070
Nickel __________ 120.0 __________6.5
Sodium __________210,000.0 __________ 2,200.0
Vanadium __________ 18.0 __________2.2
DOCUMENT 2 (CONTINUED)
Not detected ____________________Detection Limit
Antimony __________ 13.0
Arsenic __________ 18.0
Barium __________ 22.0
Beryllium __________ 1.1
Cadmium __________ 1.1
Potassium __________ 650.0
Selenium __________ 18.0
Silver __________ 4.3
Thallium __________ 1.8
Zinc__________ 4.3
DOCUMENT 4. Field Identification Alum Sludge Matrix: Solid
Detectable levels of the following were found:
Parameter= % Result Detection limit
Moisture 16.9 0.1
Parameter= (ug/g) Result Detection Limit
Aluminum __________ 53,000.0 __________ 110.0
Arsenic __________ 18.0 __________ 8.5
Calcium __________ 97.0 __________ 11.0
Chromium __________ 50.0 __________ 1.1
Copper __________ 3.1 __________ 2.2
Iron __________ 19,000.0 __________ 33.0
Lead 9.5 5.4
Magnesium __________ 15.0 __________ 11.0
Manganese __________ 2.6 __________ 0.54
Mercury __________ 2.1 __________ 0.24
Nickel __________ 4.4 __________ 3.3
Vanadium __________ 32.0 __________ 1.1
Zinc __________ 3.1 __________ 2.2
NOT DETECTED Detection Limit (ug/g)
Antimony __________ 6.5
Barium __________ 11.0
Beryllium __________ 0.54
Cadmium __________ 0.54
Potassium __________ 3.30
Selenium __________ 3.4
Silver __________ 2.2
Sodium __________ 1.10
Thallium __________ 0.85
Zinc __________
9/26/91 test 'Volatile Organics' Analysis of Alum Sludge by Resource Analysts, Inc,
Subsidiary of MILLIPORE.
This study found concentration of 37 Volatile Organics below EPA'sdetection limit.
9/26/91 Test of "Alum Sludge" Using EPA Test Methods for the Evaluation of Solid Waste.
Section 7.1 Ignitability Sample could not be ignited in 30 seconds.
Section 7.2 Corrosivity
(9/23/91) "A 25 g portion of the nonaqueous sample was added to 25 mL deionized water. The mixture was stirred occassionally over the course of 30 minutes, then allowed to stand undisturbed for one hour. At this point, the pH of the supernatant was 2.18
Section 7.3 Reactivity. 25 mg sample added to 25 mL water. partial suspension which settled, forming no gas. No evidence of any reaction was observed.
Back to Penobscot Bay Watch